Trailer tow turn signalsĭaytime Running Lamps (DRL) (Canada), Foglamps (2001-2002 export only) The power distribution box is located in the engine compartment.ĭelayed accessory, Power windows (2004-2005), Audio (2004-2005) These relays are located on the reverse side of the passenger compartment fuse panel.
#02 FORD EXPLORER FUEL PUMP REPLACEMENT MANUAL#
Reverse park aid, Brake shift interlock, Approach lamp relay coil (2001-2002), IVD switchĪutomatic dimming mirror, Digital transmission range sensor, Backup lampsĭigital transmission range sensor, PWR feed to fuse #28 (Start feed)ĭaytime Running Lamps (DRL), Remote solenoid, DEATC climate controller, Manual climate control, Manual climate control temp blend actuator Mode-Temperature actuator for auxiliary climate control, Trailer tow battery charge coil, TPMS (2004-2005)
#02 FORD EXPLORER FUEL PUMP REPLACEMENT DRIVER#
Instrument cluster, Compass, Flasher coilĢ001-2003:Brake pedal position switch, Driver brake applied relay, Redundant cruise deactivate switch Memory driver seat switch, Driver seat module, Body Security Module (BSM), PATS LED, Sunload sensor (2001-2003) coil, Battery saver, Interior lamps (front and rear), Glove compartment lamp Power mirror, Manual climate control, TPMSĭelayed acc. Rear wiper module, Cluster, TPMS (2001-2003) Overdrive cancel switch, Flex fuel sender (2001-2003) Heated backlight relay coil, Heated seat module (2001-2002), Temp blend actuator (2001-2002), A/C clutch contact Radio, Amplifier, Power antenna (2001-2002), DVD Memory seat module, Driver power seat (2003-2005), Driver power lumbar (2005) The fuse panel is located below the instrument panel on the driver’s side. If a fuse blows again contact a qualified service center.Use always an intact fuse of the same color. Never replace a broken fuse with anything other than a new fuse.Using a fuse with a higher amperage rating can cause severe wire damage and could start a fire. Always replace a fuse with one that has the specified amperage rating.Always disconnect the battery before servicing high current fuses.Before replacing fuses check that the key has been removed from the ignition and that all the services are switched off and/or disengaged.